Inbound/Outbound Policies - Outbound Policy - Dynamix UM-A User Manual

4.3.3.16.3.2 Inbound/Outbound Policies – Outbound Policy
The Outbound Policy allows you to filter outbound (from the user side LAN to the WAN) packets
based on a set of rules. This enables you to deny access to different sources and thus increase security.
A table of outbound policies is displayed with the following information. If there are no policies, then a
message stating "No Entries in Outbound Policy Database" will be displayed in place of the table.
IP Address: This field specifies the IP address or addresses to which the policy applies. Both
the source IP (SrcIP) and destination IP (DesIP) are specified here.
Port #: This field specifies the Port number to which the policy applies. Both the source port
(SrcPort) and destination port (DesPort) are specified here.
Prot.: Short for protocol, this is the protocol to which the policy applies.
Act. Short for action, this field specifies two possible actions: allow and deny.
Opt. Filtering: Optional Filtering field specifies the time period to which the policy applies.
Up: Clicking on this button will move the corresponding policy up one space in the table.
Dn: Short for down, clicking on this button will move the corresponding policy down one
space in the table.
4/1 Port ADSL Router P 114