Dynamix UM-A User Manual page 60

C. Ethernet Mode Setting :
The Ethernet Mode configuration page allows you to set the LAN port into the following modes:
AutoSense: The ADSL Router will automatically sense which mode to use, selecting
between 100 Mbps Full Duplex, 100 Mbps Half Duplex, 10 Mbps Full Duplex, and 10 Mbps
Half Duplex. This is the default setting.
100 Mbps Full Duplex: Data can be transferred and received simultaneously at the transfer
rate of 100 Mega-bits per second.
100 Mbps Half Duplex: Data cannot be transferred and received at the same time. For
example, data can be sent, and once the transmission is complete, data can be received. This
is done at a transfer rate of 100 Mega-bits per second.
10 Mbps Full Duplex: Data can be transferred and received simultaneously at the transfer rate
of 10 Mega-bits per second.
10 Mbps Half Duplex: Data cannot be transferred and received at the same time. For example,
data can be sent, and once the transmission is complete, data can be received. This is done at
a transfer rate of 10 Mega-bits per second.
Note : Default is "AutoSense".
Save Configuration : Clicking this will link you to the Save Settings / Reboot page.
4/1 Port ADSL Router P 59