Appendix C Troubleshooting Guide - Dynamix UM-A User Manual

Appendix C Troubleshooting Guide

The Troubleshooting Guide provides answers to common problems regarding the ADSL Router
settings, connections, and computer settings.
I changed the LAN IP Address in the LAN configuration page and my PC is no longer able to
detect the ADSL Router.
After changing the LAN IP Address of the ADSL Router, you must do one of the following things
before a PC is able to recognize the ADSL Router:
Open the MS-DOS prompt and run ipconfig/release followed by ipconfig/renew.
Reboot the computer.
Disconnect the ADSL Router from the computer, and then reconnect it.
Turn off the ADSL Router and then turn it back on.
Only one computer can connect to the ADSL Router or my ADSL Router can only recognize one
computer.
There are several things to check:
Make sure that the DHCP server is in Multiple User mode. To do this, go to the LAN
Configuration page and under the User Mode field, select Multi-User.
Make sure that the NAT is configured for multiple User IPs. To do this, go to the NAT
configuration Page and change the NAT type of the particular session to Dynamic NAPT.
If the problem persists, make sure that the computer that cannot connect has the appropriate
network settings.
4/1 Port ADSL Router P 135