Ipv6 Bgp Route Reflector Configuration Example - HP HPE FlexNetwork 7500 series Configuration Manual

PrefVal : 32768
MED
Path/Ogn: i
* i Network : 9::
NextHop : 9::1
PrefVal : 0
MED
Path/Ogn: i
* >i Network : 10::
NextHop : 9::1
PrefVal : 0
MED
Path/Ogn: i
* >i Network : 50::
NextHop : 10::2
PrefVal : 0
MED
Path/Ogn: 65008i
The output shows that Switch C has learned the route 50::/64.
# Verify that Switch C can ping hosts on network 50::/64. (Details not shown.)

IPv6 BGP route reflector configuration example

Network requirements
As shown in
Switch B, and between Switch C and Switch D.
Configure Switch C as a route reflector with clients Switch B and Switch D.
Figure 83 Network diagram
Loop0
1.1.1.1/32
Vlan-int10
1::1/64
Switch A
AS 100
Configuration procedure
1. Configure IPv6 addresses for interfaces and IPv4 addresses for loopback interfaces. (Details
not shown.)
2. Configure IBGP and EBGP connections and advertise network routes through IPv6 BGP:
: 0
: 0
: 0
: 0
Figure 83, run EBGP between Switch A and Switch B, run IBGP between Switch C and
Vlan-int100
100::1/96
Loop0
2.2.2.2/32
Vlan-int100
100::2/96
Switch B
Loop0
3.3.3.3/32
Vlan-int102
Vlan-int101
102::1/96
101::1/96
Switch C
Vlan-int101 Vlan-int102
101::2/96 102::2/96
363
OutLabel : NULL
PrefixLen : 64
LocPrf : 100
OutLabel : NULL
PrefixLen : 64
LocPrf : 100
OutLabel : NULL
PrefixLen : 64
LocPrf : 100
OutLabel : NULL
AS 200
Loop0
4.4.4.4/32
Switch D