Polaris msx 110 Service Manual page 28

Oil Change Procedure
4. Remove each of the two fuel injector and ignition coil
wiring harness connectors.
5. Remove the upper oil feed hose from the top of the oil
storage tank. Locate either a two--liter plastic bottle or
a 5--foot length of hose with a male--to--male hose
coupler.
6. Insert the oil supply hose into the two--liter bottle inside
the engine compartment, or, insert the coupler into
both ends of the hoses and hang the entire length of
hose over the side of the watercraft. Position this hose
into a oil pan or oil containment container.
7. Insert the safety lanyard into the stop switch. Press
and hold the start button for no more than 15 seconds.
Release the start button for at least 30 seconds.
Repeat this process three to four times, or until little or
no oil is pumped out of the sump and into the container.
8. Locate the oil filter cover cap. Remove the cap and
remove the o--ring and filter element. Replace filter
element and o--ring with new parts.
9. Reinstall oil filter cover cap and torque to 24 Nm (17
ft.lbs.)
10. Clean oil tank fitting with brake cleaner or acetone,
then reinstall the oil supply hose to the oil storage tank.
Torque gear clamp to 30 in.lbs.
11. Fill to oil tank with 3.4 -- 3.7 qts. (3.3 -- 3.5 L) of Polaris
PS--4 Synthetic Marine engine oil.
NOTE: Never add more than 3.7 qts. (3.5 L)
12. Reconnect the fuel injector and ignition coil wiring
harness connectors.
13. Start engine and idle for 30 seconds. Stop engine and
re--check engine oil level.
14. Add engine oil until level is at the low mark on dipstick.
NOTE: The oil level will increase as the engine warms up to operating temperature.
2004 Four Stroke PWC Service Manual
MAINTENANCE
REMOVE THIS HOSE
CAP
ELEMENT
O--RING
2.11