PROPULSION
Stator Assembly
STUBSHAFT
O- -RINGS
BEARING
BEARING SPACER
SEALS
(LIPS FACE IMPELLER)
STATOR HOUSING
BEARING
IMPELLER SPACER
IMPELLER
100 ft.lbs. (138 Nm)
ASSEMBLY NOTES
Impeller Torque: 100 ft.lbs. (138 Nm) Apply Loctite 242 to threads.
Bearing Spacer Length: 1.730 in. 43.94mm (Service Limit)
Apply light film of Premium grease to seal lips, o- -rings, and stubshaft during installation.
Bearing spacer length is critical to driveline operation. Replace if length is smaller than service limit.
Seal springs and / or seal lips must not be folded over, stretched, torn, etc. by impeller spacer during stubshaft installation.
6.5
2004 Four Stroke PWC Service Manual