Polaris msx 110 Service Manual page 15

Service Tools
PW- - 46981 - - REQUIRED TOOL
CRANKSHAFT HAND CRANK (BARRING TOOL)
USED TO ROTATE CRANKSHAFT
PW- - 46982 - - REQUIRED TOOL
GEAR REMOVAL TOOL
USED TO REMOVE BALANCE SHAFT GEAR WHEN USED WITH
PW- -46989 GEAR REMOVER BOLT.
PW- - 46983 - - REQUIRED TOOL
PISTON RING COMPRESSOR
USED TO INSTALL PISTONS INTO ENGINE BLOCK
PW- - 46984 - - REQUIRED TOOL
ENGINE STAND ADAPTER PLATE
PW- - 47054
ENGINE STAND ADAPTER SLEEVE
ATTACHES TO REAR OF ENGINE BLOCK. ALLOWS TECHNI-
CIAN TO ROTATE ENGINE DURING DISASSEMBLY AND RE- -
ASSEMBLY.
ADAPTER SLEEVE EXPANDS MOUNTING OPTIONS WHEN
USING DIFFERENT ENGINE STANDS.
1.14
GENERAL INFORMATION
PW- - 46989 - - REQUIRED TOOL
MAGNET ROTOR / GEAR REMOVER BOLT
USED TO REMOVE MAGNET ROTOR AND BALANCE SHAFT GEAR WHEN
USED WITH PW- -46982.
PW- - 46991 - - REQUIRED TOOL
VALVE COMPRESSOR TOOL
USED TO COMPRESS VALVE SPRINGS WITH ENGINE EITHER
INSTALLED OR REMOVED FROM WATERCRAFT HULL.
PW- - 47077 - - REQUIRED TOOL
CAMSHAFT ALIGNMENT TOOL
INSTALLS INTO CAMSHAFT TO LOCK INTO BDC POSITION.
PW- - 47079 - - REQUIRED TOOL
TIMING CHAIN INSTALLATION TOOL
ROUTES TIMING CHAIN THROUGH ENGINE CRANKCASE DUR-
ING INSTALLATION.
PW- - 47108 - - REQUIRED TOOL
TIMING CHAIN WEDGE AND HOOK TOOL
USED DURING TIMING CHAIN INSTALLATION
2004 Four Stroke PWC Service Manual