PROPULSION
Driveshaft / Bearing Carrier Assembly
COUPLER GUARD
SHIM WASHERS
TAPERED SPACER
COUPLER ASSEMBLY
DRIVESHAFT
BUMPER
BEARING CARRIER
14 ft.lbs. (19 Nm)
ASSEMBLY NOTES
Bearing Carrier Fastener Torque: 14 ft.lbs. (19 Nm) Tighten in criss- -cross pattern.
Driveshaft Run Out Service Limit: .005" (.13mm)
Fit tapered end of spacer over driveshaft taper.
Bumper MUST be installed between impeller and driveshaft.
Use light film of premium grease on carrier seals and shaft to assist in driveshaft installation.
Apply small amount of Premium grease to tapered spacer inside diameter.
During assembly, perform the driveshaft shim procedure as outlined on page 6.10.
6.6
2004 Four Stroke PWC Service Manual