Table of Contents
Advertisement
CDM-Qx Satellite Modem
Installation
#10 Shoulder Screw
Support Bracket
#10 Bracket Bolt
Figure 2-1. Installation of the Optional Rear-Mounting Support Brackets
2.3
Configuration
There are no internal jumpers to configure. All configuration is carried out entirely in
software. The unit should first be configured locally, using the front panel keypad and
display. The unit will ship with a default Viterbi 192 kbps, QPSK, Rate 3/4 configuration.
Refer to the 'FRONT PANEL OPERATION' chapter for details on how to fully
configure the unit for the desired operating parameters.
Note:
The auto-sensing AC power supply does not require any adjustments; simply plug
in the supplied line cord.
Equipment Rack
Rear Mounting Rail
#10 Flat Washer
#10 Flat Washer
#10 Split Washer
#10 Hex Nut
2–3
Back of unit
Revision 6
MN/CDMQx.IOM
Advertisement
Table of Contents
