Comtech EF Data CDM-Qx Installation And Operation Manual page 173

CDM-Qx Satellite Modem
Remote Control
Note: The following codes are used in the 'Response to Command' column:
= Message ok
? Received ok, but invalid arguments found
* Message ok, but not permitted in current mode
# Message ok, but unit is not in Remote mode
~ Time out of an EDMAC pass-through message
$ Message ok, but no card is installed in the slot.
@ Message ok, but sending Tx command to an Rx card or vice-versa.
^ Message ok, but unit is in Ethernet mode.
C-7
Revision 6
MN/CDMQx.IOM