Projection Head And Pedestal - Christie CP2000-SB Setup Manual

Section 3: Installation & Setup
3.2

Projection Head and Pedestal

STEP 1 - Secure Projection Head to Pedestal
a. Roll the pedestal as close as possible to its permanent location, with its front toe facing the port win-
dow wall.
b. Inside the pedestal, at the rear of the top frame, turn the knob to extend the safety prop above the ped-
estal frame. This stop will then elevate the rear of the projection head until fingers are safely out of the
way. See Figure 3-1 Step 1.
c. Lift the projection head onto the pedestal, aligning the four threaded rods with the four holes in the
pedestal frame. Warning! Requires at least two people. For cable connections, maintain cable ties
that have been trimmed, and those that are not. The front of the head will sit on the front of the pedes-
tal frame and the rear will be elevated by the safety prop.
d. Retract the safety prop until the rear of the projection head sits on the rear of the pedestal frame. All
four threaded rods will be fully inserted through the holes in the top of the pedestal. Secure the safety
prop (do not leave loose).
e. Secure head-pedestal assembly with four washers/nuts tightened snugly on to the four threaded rods.
STEP 2 - Position CP2000-SB at Port Window
Roll the projector until its base is approximately 2 feet from the port window wall, 3 feet if auxiliary lens
mount will be added (optional). Center with the theatre screen () if possible (Figure 3-2, A). If forced
to be off-center (such as when a film projector is already present), try to optimize aim as shown in Figure
3-2, B. This will slightly increase side keystoning, but will minimize required horizontal lens offset.
NOTE: Unlike film projectors, it is best to keep the projector lens surface as parallel to the screen as pos-
sible, even if it is significantly above the screen center.
3-2
Figure 3-1 Assembling Projection Head with Pedestal
CP2000-SB Setup Guide
020-100249-02 Rev. 1 (05-2009)