Setting Up The Projector Head; Leveling The Projector - Christie Mirage SST Installation And Setup Manual

Hide thumbs Also See for Mirage SST:

Table of Contents

b) Adjust the boresight (on page 49).

c) Adjust the fold mirror (on page 51).

d) Optimize the integrator zoom and focus (on page 53).

e) Adjust the DMD convergence (on page 55).

Align the image with lens zoom and focus (on page 56).

g) Run Auto Setup to optimize display settings (on page 56).

7. Configure Mirage SST to work with Christie Link (on page 57).

Setting up the projector head

1. Position the projector as perpendicular to the screen as possible, even if significantly above the

screen center.

When a particularly short throw distance combines with a wide screen, you may have to forfeit

some aim and stay more perpendicular to the screen. In such cases, some lens offset can

reduce the keystone distortion.

For information on positioning the projector in a rigging frame, refer to the Assembling the

Precision 1 Rigging Frame (P/N: 020-102719-XX) or Upgrading the Boxer Rigging Frame (P/N:

020-102746-XX) instruction sheet.

2. Level the projector (on page 26) as required.

3. Install the projection lens (on page 27).

4. If required, connect the Ethernet cable (on page 61) from the Ethernet port on the projector

head to the input source.

5. Connect the projector head to AC power (on page 28).

Use the projector feet to level the projector.

1. To adjust the vertical position of the projector, extend or retract the adjustable feet on the

bottom of the projector using the adjustable knobs on the feet.

Christie recommends adjusting the feet from the side or rear of the projector and not the front

to avoid exposure to the output light.

Mirage SST Installation and Setup Guide

020-102956-08 Rev. 1 (09-2022)

If printed, please recycle this document after use.

Installation and setup

Table of Contents

Mirage sst-6p