Setting Up The Projector Head; Lifting And Positioning The Projector - Christie Eclipse Installation And Setup Manual

d) Connect the fiber optic cable (on page 40) from the laser illumination source to the
projector head.
e) Ensure a qualified electrician connects the AC power to the laser illumination source.
3. Set up the chiller unit.
4. Perform initial system start-up (on page 45) or turn on the system (on page 46).
5. Calibrate the lens motor (on page 57).
6. Adjust the image.
a) Rotate the integrator rod (on page 53).
b) Adjust the horizontal and vertical (on page 54) boresight.
c) Adjust the convergence (on page 55).
d) Adjust images with full light (on page 57).
7. Complete the installation checklist (on page 61).
8. Configure Christie Eclipse to work with Christie Link (on page 73).

Setting up the projector head

1. Position the projector as perpendicular to the screen as possible, even if significantly above the
screen center.
When a particularly short throw distance combines with a wide screen, you may have to forfeit
some aim and stay more perpendicular to the screen. In such cases, some lens offset can
reduce the keystone distortion.
2. Position the projector.
3. Install the projection lens (on page 30).
4. Connect the projector head to AC power (on page 34).

Lifting and positioning the projector

Safely lift and position the projector in the location where it will be used.
To tilt the projector more than 15° up or down, remove the feet and mount the projector to a custom
engineered mounting system designed specifically for this projector and installation. If the projector is
to be installed beyond 15° of tilt, contact the Christie Custom Fulfillment team for additional
consultation.
Warning! If not avoided, the following could result in death or serious injury.
• Do not install or operate the projector in any position that does not meet the stated product
specifications for alignment and orientation.
1. Position the projector so it is centered and parallel with the screen. If space is limited, aim the
projector slightly off-center and use lens offset to center the image on the screen.
2. To adjust the vertical position of the projector, extend or retract the adjustable feet on the
bottom of the projector using the adjustable knobs on the feet.
only applies to a projector being installed on a flat pedestal?
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
26