Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
2
Select frequency area in the Frequency drop-down list.
3
Click "OK".
4
Reset in order to make the changes take effect, see
8.5.7
Enable Carriers
The IPBS/IPBL has 5 carriers for the North American frequency band and 10 carriers for the
other frequency bands. Under all normal circumstances all carriers should be enabled.
To enable or disable carriers:
1
Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see
Select Mode
2
Select/clear the Enabled Carriers check boxes.
3
Click "OK".
8.5.8
Local R-Key Handling
With this option enabled keypad information is handled locally. If this option is disabled
keypad information is sent transparently to the IP-PBX. Local R-key handling is further
described in
1
Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see
Select Mode
2
To enable, select the Local R-Key Handling check box.
NOTE: To access the Local R-Key Handling check box, the SIP protocol has to be
selected on the Master, see
3
Click "OK".
8.5.9
No Transfer on Hangup
If enabled it will not be possible to do a transfer by hanging up the handset. R4 must be
pressed (see
1
Select DECT > System.
NOTE: To access the System tab, the Master mode has to be activated, see
Select Mode
2
To enable, select the No Transfer on Hangup check box.
3
Click "OK".
8.5.10 Configure Coder
Select the preferred coder, and enter the desired frame length. If exclusive is selected for
the coder the IPBS/IPBL is forced to use that coder. With Silence Compression enabled no
information is sent during pauses in the conversation, this is used to save bandwidth.
Note: When exclusive is enabled for a coder it might be impossible to make calls outside
the IP-DECT system.
15 February 2012 / Ver. H
on page 94.
Appendix
C.
on page 94.
8.5.16 Configure Gatekeeper
Appendix
C).
on page 94.
TD 92579EN
8.22 Reset
on page 138.
8.5.13
8.5.13
on page 95.
8.5.13
91
Need help?
Do you have a question about the IPBS and is the answer not in the manual?
Questions and answers