Configuration; Requirements; Web Browser Requirements; Access The Gui - ASCOM IPBS Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
7

Configuration

This section describes how to configure the IPBS and IPBL using the web interface. The
recommended order to configure the equipment in the IP-DECT system is as follows:
1 Configure the Mobility Master, see
2 Configure the Standby Mobility Master, see
Master
3 Configure the Pari Master, see
4 Configure the Standby Pari Master, see
page 52.
5 Configure the Master, see
6 Configure the Standby Master, see
7 Configure the Radios, see
7.1

Requirements

The following is required in order to configure the IP-DECT system:
• PC
• 10/100base-T Ethernet connection
7.1.1

Web Browser Requirements

To use the interface properly, the web browser has to meet the following requirements:
• HTTP 1.1 protocol
• HTML 4.0 protocol
• XML/XSL Version 1.0
The GUI has been tested with Internet Explorer 7.x and Firefox 3.x, but can also be
operated with other browsers in compliance with the requirements above.
7.2

Access the GUI

Note: To access the GUI for an IPBS/IPBL using secure web access (https), the certificate for
the IPBS/IPBL can be installed in the web browser to avoid getting certificate error
messages. See
The GUI interface is accessed through a standard web browser. It is possible to use the
name, ipbs-xx-xx-xx and ipbl-xx-xx-xx, where xx-xx-xx is the end of the MAC address.
Note: The IPBL name is always ipbl-xx-xx-xx regardless if LAN1 (MAC xx-xx-xx-xx-xx) or
LAN2 (MAC yy-yy-yy-yy-yy) is used.
It is also accessed by entering http://xxx.xxx.xxx.xxx. In this address, xxx.xxx.xxx.xxx should
be replaced with the IP address determined in
Access the GUI and change the default password as described in
Password on page 44.
15 February 2012 / Ver. H
on page 50.
7.6 Configure the Pari Master
7.8 Configure the Master
7.11 Configure the Radio
Appendix G: Install Certificate in the Web Browser
7.4 Configure the Mobility Master
7.5 Configure the Standby Mobility
7.7 Configure the Standby Pari Master
on page 52.
7.9 Configure the Standby Master
on page 54.
on page 166.
7.2.1 Determine the IP Address
7.2.2 Change the Default
TD 92579EN
on page 50.
on page 51.
on
on page 53.
on page 43.
42