Configure The Standby Master - ASCOM IPBS Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
3 Configure LDAP user name and password, select the Write Access check box, see
8.4.1 Configure LDAP Server
4 Set a static IP address and set DHCP to off, see
80.
5 Set the mode to Master, see
6 Perform a reset to restart the IPBS/IPBL in Master mode, see
138.
7 Select system name and password, see
on page 89.
8 Set default language, see
9 Select supplementary services, see
page 92.
10 Set Master id, see
11 Enter gatekeeper IP address or ID, see
12 Connect to a Mobility Master, see
page 98.
13 Enter IMS3 IP address, see
14 Enter the Time Server address, see
15 Reset in order to make the configuration changes take effect, see
page 138.
7.9

Configure the Standby Master

It is recommended to have a Standby Master in the IP-DECT system. This section describes
how to configure a Standby Master. Each configuration step is briefly described in the step
list below, for more detailed information see the corresponding subsection in
on page 60.
1 Determine the address and access the GUI, see
2 Change the default password, see
3 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server. Alternative LDAP server must not be entered. Select the Enable check
box, see
4 Set a static IP address and set DHCP to off, see
80.
5 Set the mode to Standby Master, see
6 Perform a reset to restart the IPBS/IPBL in Standby Master mode, see
page 138.
7 Enter system name and password, this should be the same system name and
password as in the Master. See
89.
8 Select supplementary services, see
page 92.
9 Set Master Id, see
10 Enter gatekeeper address, see
11 Connect to a Mobility Master, see
page 98.
15 February 2012 / Ver. H
on page 82.
8.5.13 Select Mode
8.5.5 Set Default Language
8.5.14 Set Master Id
8.7.1 Configure Messaging
8.4.3 Configure LDAP Replicator
8.5.1 Change System Name and Password
8.5.14 Set Master Id
8.5.16 Configure Gatekeeper
8.2.2 Set a Static IP Address
on page 94.
8.5.1 Change System Name and Password
on page 90.
8.5.12 Configure Supplementary Services
on page 94.
8.5.16 Configure Gatekeeper
8.5.21 Connect Master to a Mobility Master
on page 103.
8.1.5 Configure the NTP Settings
7.2 Access the GUI
7.2.2 Change the Default Password
on page 83.
8.2.2 Set a Static IP Address
8.5.13 Select Mode on page 94.
8.5.12 Configure Supplementary Services
on page 94.
8.5.21 Connect Master to a Mobility Master
TD 92579EN
on page
8.22 Reset on page
on
on page 95.
on
on page 68.
8.22 Reset on
8 Operation
on page 42.
on page 44.
on page
8.22 Reset on
on page
on
on page 95.
on
53