Events - ASCOM IPBS Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
object-related alarms are automatically cleared after a timeout period of 30 minutes.
Active alarms are also cleared if the related object is restarted.
For a description of the attributes, see the table below.
Figure 30.
Attribute
Time
Code
Severity
Remote
Source
Description

8.21.4 Events

Under Diagnostics > Events is history of alarms and errors displayed including active
alarms. Click "Clear" in the top-right corner to clear the list of alarms and errors.
For a description of the attributes, see the table below.
Figure 31.
Attribute
Time
Type
15 February 2012 / Ver. H
Description
The date and time when the alarm is issued.
A unique number that identifies the alarm. Click the
code to get more detailed information about the
alarm. For a list of possible codes and their
descriptions, see 10.2 Fault Code Descriptions
page 142.
It has three possible states:
• Critical - Immediate action is
required. It is displayed, for
example, if a managed object goes
out of service.
• Major - Urgent action is required. It
is displayed, for example, if the
capability of the managed object is
severely degraded.
• Indeterminate - Level of severity
cannot be determined
The IP Address of the object that reported the alarm.
Click the IP address to access the object.
The software module that reported the alarm.
Together with the code it uniquely identifies an
alarm.
A textual description of the alarm.
Description
The date and time when the alarm, error is issued or
cleared.
The status of the fault. It has four possible states:
• Alarm - Alarms displayed in red are
active alarms
• Alarm cleared - The alarm is already
cleared
• Alarm timeout - The alarm
exceeded the timeout period
• Error - Refers to faults that are not
active for a specific time.
TD 92579EN
on
135