Update Firmware; Update The Boot File; Update The Rfps - ASCOM IPBS Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
Note: If the IPBS2 is configured and the configuration is taken from IPBS1, some lines in
the configuration will be skipped by IPBS2. This is because it is different hardware in IPBS1
and IPBS2 and some configuration lines are not applicable in IPBS2.

8.18.2 Update Firmware

The software can be updated. Follow the steps below to update IPBS/IPBL with the
firmware. Download firmware from the IP-DECT system provider.
Note: If this operation is interrupted, the firmware in the device will be defect. If a
firmware upload is for any reason interrupted, the firmware must be uploaded again. Do
not execute a reset before the firmware upload is complete. For information on how to
load new firmware if the IPBS/IPBL is unreachable through the web GUI, see
Firmware Using the Gwload Tool
1 Select Update > Firmware.
2 Click "Browse..." and browse to the firmware file.
3 Click "Upload"
4 Reset in order to make the changes take effect, see

8.18.3 Update the Boot File

1 Select Update > Boot.
2 Click "Browse..." and browse to the boot file.
3 Click "Upload".
4 Reset in order to make the changes take effect, see

8.18.4 Update the RFPs

This section only applies to the IPBL.
The firmware can be updated. Follow the steps below to update RFP. Download firmware
from the IP-DECT system provider.
In the RFP status list, information on connected RFPs are displayed.
1 Select Update > RFPs.
2 Click "Browse..." and browse to the RFP update file.
3 Click "Upload".
15 February 2012 / Ver. H
on page 142.
TD 92579EN
10.1 Load
8.22 Reset on page 138.
8.22 Reset on page 138.
131