Replacing Master Hardware In Multiple Master System; Diagnostics; Logging - ASCOM IPBS Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
pari master pari master
Figure 33. System with several Mobility Masters
Following limitations apply during upgrade:
• Using software version 3.x.x at site A and software version 4.x.x at site B:
- 3.x.x users get No Access when located in site B (4.x.x).
- Idle display does not work for 4.x.x users located in site A (3.x.x software).
• Using software version 3.x.x at site A and software version 5.0.x at site B:
- 3.x.x users get No Access when located in site B (5.0.x).
- 5.0.x users get No Access when located in site A (3.x.x).
• Using software version 4.x.x at site A and software version 5.0.x at site B:
- 5.0.x users get No Access when located in site A (4.x.x).

8.20 Replacing Master Hardware in Multiple Master System

If a faulty Master IPBS is replaced with a new one and the same configuration shall be
applied to the new one, then the faulty Master must have been disconnected from the
system more than 2 minutes before the new Master is connected, otherwise all the
subscription data will be lost.
For information on how to load a configuration on the new Master, see
Configuration

8.21 Diagnostics

8.21.1 Logging

The IPBS/IPBL can generate a number of logs which can be useful when supervising and
troubleshooting the IP-DECT system. For information on how to collect the log files, see
8.1.6 Configure Logging
15 February 2012 / Ver. H
mobility mobility
master master
master master
master master
radio radio radio radio
Site A Site A
Radio coverage area
on page 130.
on page 69. For a description of each log, see the table below.
TD 92579EN
mobility mobility
master master
master master
master master
pari master pari master
radio radio radio radio
Site B Site B
8.18.1 Update
133