Configure The Standby Pari Master; Configure The Master - ASCOM IPBS Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway (software version 5.0.x)
22 Assign PARI, see
23 Enter SARI, see
24 Enter IMS3 IP address, see
25 Enter the Time Server address, see
26 Reset in order to make the configuration changes take effect, see
page 138.
7.7

Configure the Standby Pari Master

It is recommended to have a Standby Pari Master in the IP-DECT system. This section
describes how to configure a Standby Pari Master. Each configuration step is briefly
described in the step list below, for more detailed information see the corresponding
subsection in
1 Determine the address and access the GUI, see
2 Change the default password, see
3 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server (Pari Master). Alternative LDAP server must not be entered. Select the
Enable check box, see
4 Set a static IP address and set DHCP to off, see
80.
5 Set the mode to Standby Master, see
6 Perform a reset to restart the IPBS/IPBL in Standby Master mode, see
page 138.
7 Enter system name and password, this should be the same system name and
password as in the Pari Master, see
page 89.
8 Select supplementary services, see
page 92.
9 Set Master Id, see
10 Enable Pari function, see
11 Enter gatekeeper address, see
12 Connect to a Mobility Master, see
page 98.
13 Enter IMS3 IP address, see
14 Enter the Time Server address, see
15 Reset in order to make the configuration changes take effect,
138.
7.8

Configure the Master

This section describes how to configure the Master. Each configuration step is briefly
described in the step list below. For more detailed information see the corresponding
subsection in
1 Determine the address and access the GUI, see
2 Change the default password, see
15 February 2012 / Ver. H
8.5.25 PARI on page 99.
8.5.26 SARI on page 100.
8.7.1 Configure Messaging
8 Operation on page 60.
8.4.3 Configure LDAP Replicator
8.5.14 Set Master Id
8.5.15 Enable PARI Function
8.5.16 Configure Gatekeeper
8.7.1 Configure Messaging
8 Operation on page 60.
on page 103.
8.1.5 Configure the NTP Settings
7.2 Access the GUI
7.2.2 Change the Default Password
on page 83.
8.2.2 Set a Static IP Address
8.5.13 Select Mode on page 94.
8.5.1 Change System Name and Password
8.5.12 Configure Supplementary Services
on page 94.
on page 94.
8.5.21 Connect Master to a Mobility Master
on page 103.
8.1.5 Configure the NTP Settings
7.2 Access the GUI
7.2.2 Change the Default Password
TD 92579EN
on page 68.
8.22 Reset on
on page 42
on page 44.
on page
8.22 Reset on
on
on
on page 95.
on
on page 68.
8.22 Reset on page
on page 42.
on page 44.
52