Stereo Decimator - Korg microARRANGER Owner's Manual

184 Effects
Filter/Dynamic
If Sweep Mode is set to LFO, the sound will change cyclically
from "a" to "i," "u," "i," then "a."
Voice Bottom
A
U
D JS X
-mod
– Max
Ribbon
JS +Y
JS –Y
Zero
etc...
h: Formant Shift
This parameter adjusts the frequency level to which the effect
is applied. If you wish to apply the effect to a higher-range
sound, set this parameter to a higher value; to apply the effect
to a lower-range sound, set this to a lower value.
h: Resonance
This parameter sets the intensity of resonance for the voice
pattern. A larger value will add more character to the sound.
Talking Modulator Control
Voice Center
Voice Top
A
I
E
O
+ Max
Zero
+ Max

014: Decimator

(Stereo Decimator)

This effect creates a rough sound like a cheap sampler
by lowering the sampling frequency and data bit
length. You can also simulate noise unique to a sampler
(aliasing).
Stereo In - Stereo Out
Left
Pre LPF Resolution
D
-mod
Sampling Frequency
LFO
Pre LPF Resolution
Right
Pre LPF
Selects whether the harmonic noise caused by a decrease in sampling fre-
quency is generated or not
a
High Damp [%]
Sets the ratio of cut of the high range
Sampling Freq (Sampling Frequency) [Hz]
Sets the sampling frequency
Src
b
Selects the modulation source of the sampling frequency
Amt
Sets the modulation amount of the sampling frequency
LFO Frequency [Hz]
Sets the LFO speed
Src
c
Selects the modulation source of LFO speed
Amt
Sets the modulation amount of LFO speed
Depth
Sets the depth of the sampling frequency LFO modulation
Src
d
Selects the LFO modulation source of the sampling frequency
Amt
Sets the LFO modulation amount of the sampling frequency
Resolution
e
Sets the data bit length
Output Level
Sets the output level
Src
f
Selects the modulation source for the output level
Amt
Sets the modulation amount of the output level
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 175
Src
g
Table , "Selects the modulation source of the effect balance," on page 175
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 175
a: Pre LPF
If a sampler with a very low sampling frequency receives very
high-pitched sound that could not be heard during playback, it
could generate pitch noise that is unrelated to the original
sound. Set "Pre LPF" to ON to prevent this noise from being
generated.
If you set the "Sampling Freq" to about 3kHz and set "Pre
LPF" to OFF, you can create a sound like a ring modulator.
e: Resolution, f: Output Level
If you set a smaller value for the "Resolution" parameter, the
sound may be distorted. The volume level may also be
changed. Use "Output Level" to adjust the level.
Wet / Dry
High Damp Output Level
Decimator
Decimator
High Damp Output Level
Wet / Dry
Off, On
0...100%
1.00k...48.00kHz
Off...Tempo
–48.00k...+48.00kHz
0.02...20.00Hz
Off...Tempo
–20.00...+20.00Hz
0...100
Off...Tempo
–100...+100
4...24
0...100
,
Off...Tempo
–100...+100
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100

