Removing The System Board - Fujitsu PRIMERGY CX250 S2 Upgrade And Maintenance Manual

System board and components
9.3.3.1

Removing the system board

Figure 130: Removing the system board
Ê Remove ten screws from the system board (see circles).
Ê Slightly lift up the system board (1) by the memory module ejectors.
Ê Carefully shift the system board in the direction of the arrow until the plug
shells disengage from the cut-outs in the connector panel (2).
Ê Hold the defective system board by the memory module ejectors and at a
slight angle lift it out of the chassis.
226 Upgrade and Maintenance Manual
CX250 S2