6.3.3.3
Removing an expansion card
Ê Remove the defective expansion card as described in
expansion card" on page
Ê If applicable, remove SFP+ transceiver modules from the expansion card,
as described in section
page
97.
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board as described in section
brackets" on page
6.3.3.4
Installing an expansion card
Ê If applicable, install a slot bracket on the new expansion card as described
in section
"Mounting expansion card slot brackets" on page
Ê If applicable, reinstall SFP+ transceiver modules on the new expansion
card, as described in section
page
92.
Ê Install the new expansion card as described in section
expansion card" on page
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overview" on page
6.3.3.5
Concluding steps
Perform the following procedures:
"Installing the mezzanine card bracket" on page 49
Ê
card) or
"Installing the mezzanine card" on page 116
card)
"Installing the server node in the server enclosure" on page 63
Ê
Ê Reconnect all external cables.
"Switching on the server node" on page 64
Ê
"Updating RAID controller firmware" on page 73
Ê
"Enabling boot watchdog functionality" on page 74
Ê
CX250 S2
Expansion cards and battery backup units
107.
"Removing an SFP+ transceiver module" on
86.
"Installing SFP+ transceiver modules" on
104.
246.
Upgrade and Maintenance Manual
"Removing an
"Mounting expansion card slot
"Installing an
(without the mezzanine
(with the mezzanine
(if applicable)
86.
"Cabling
111