Replacing A 10 Gbt Mezzanine Card; Required Tools; Preliminary Steps; Removing The 10 Gbt Mezzanine Card - Fujitsu PRIMERGY CX250 S2 Upgrade And Maintenance Manual

Expansion cards and battery backup units
6.4.6

Replacing a 10 GbT mezzanine card

Upgrade and Repair Units (URU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
6.4.6.1

Required tools

Preliminary and concluding steps: tool-less
●
Main steps:
●
– Phillips PH2 / (+) No. 2 screw driver
6.4.6.2

Preliminary steps

Perform the following procedures:
Ê Locate the desired server node with the ID button.
"Shutting down the server node" on page 45
Ê
Ê Remove all external cables from the server node.
"Removing the server node from the server enclosure" on page 46
Ê
6.4.6.3

Removing the 10 GbT mezzanine card

Ê Remove the defective mezzanine card as described in section
the 10 GbT mezzanine card" on page
128 Upgrade and Maintenance Manual
127.
"Removing
CX250 S2