Figure 45: Installing the expansion card (B)
Ê Place the riser module onto the chassis (1).
Ê Secure the riser module with two screws (2).
Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, please refer to section
overview" on page
6.3.1.5
Concluding steps
Perform the following procedures:
"Installing the mezzanine card bracket" on page 49
Ê
card) or
"Installing the mezzanine card" on page 116
card)
"Installing the server node in the server enclosure" on page 63
Ê
Ê Reconnect all external cables.
"Switching on the server node" on page 64
Ê
"Updating RAID controller firmware" on page 73
Ê
CX250 S2
Expansion cards and battery backup units
246.
Upgrade and Maintenance Manual
"Cabling
(without the mezzanine
(with the mezzanine
(if applicable)
105