Main memory
V
CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Operation modes" on page
7.3.3
Removing a memory module
Figure 96: Removing memory modules (A)
Ê Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector.
Figure 97: Removing memory modules (B)
Ê Remove the ejected memory module.
7.3.4
Concluding step
Perform the following procedures:
"Installing the memory slot air ducts" on page 61
Ê
Ê If a BBU is installed connect the BBU cable to the BBU connector on the
mezzanine SAS RAID controller described in section
boards" on page
"Routing the BBU cable" on page
180
251,
figure 152
and route the cable as described in section
159.
Upgrade and Maintenance Manual
175.
"Connectors on the
CX250 S2