Establishing The Basic Configuration For Subscribers - Nomadix Access gateway User Manual

Choose an appropriate physical location that allows a minimum clearance of 4cm either
1.
side of the unit (for adequate airflow).
Connect the Access Gateway to the router, then connect the Access Gateway to the
2.
customer's subscriber port.
Connect the power cord and turn on the Access Gateway.
3.
Go to "Establishing the Basic Configuration for Subscribers" on page
4.

Establishing the Basic Configuration for Subscribers

When you have successfully established the start up configuration and installed the unit onto
the customer's network, connect to the Access Gateway via Telnet. You must now set up the
basic configuration parameters for subscribers, including:
Setting the DHCP Options

you to assign IP addresses automatically (to subscribers who are DHCP enabled). The
Access Gateway can "relay" the service through an external DHCP server or it can be
configured to act as its own DHCP server.
Setting the DNS Options

meaningful URLs into their browsers (instead of complicated numeric IP addresses).
DNS converts the URLs into the correct IP addresses automatically.
68
To Subscribers
–
Rear View
– DHCP (Dynamic Host Configuration Protocol) allows
DNS (Domain Name System) allows subscribers to enter
A G
CCESS
To Network
68.
Installing the Access Gateway
ATEWAY