Table of Contents
Advertisement
A
G
CCESS
ATEWAY
With the ICC feature enabled, subscribers can increase or decrease their own bandwidth
dynamically, and also adjust the pricing plan for their service.
NSE releases 8.2 and later enable or disable bandwidth policies for bandwidth management
and group bandwidth management policies. You can specify settings for each individual WAN.
From the Web Management Interface, click on
1.
Management.
2.
If required, click the check box for
available on the AG2300 platform because Bandwidth Management is always enabled).
If you enabled Bandwidth Management, enter the uplink and downlink speeds (in Kbps)
3.
in the appropriate fields.
Setting the uplink or downlink speeds to anything greater than what your product
supports is prevented by the NSE. Please refer to
page 315
If required, select Group Bandwidth Policies. Bandwidth Management must be enabled
4.
before you can enable and specify Group Bandwidth Policies.
Note: In NSE releases 8.2 and later, the Bandwidth Management page only globally Enables and
Disables Bandwidth Management and Group Bandwidth Policies. Bandwidth settings themselves
are set for each WAN interface in Ethernet Ports/WAN.
If you made any changes to the settings on this screen, you must click the check box for
5.
Reboot after changes are saved?
Click on the
6.
Reset
button if you want to reset all the values to their previous state.
System Administration
The Bandwidth Management screen appears:
for your product's capabilities.
button to save your changes and reboot the system, or click on the
Submit
Configuration
Bandwidth Management Enabled
(the Access Gateway must be rebooted).
, then
Bandwidth
(this field is not
"Product Specifications" on
99
Advertisement
Table of Contents
