Table of Contents
Advertisement
A
G
CCESS
ATEWAY
2.
System administrators can set the properties for each room from the subscriber side of the
Access Gateway. The system automatically detects which port number the administrator is
using and allows them to enter the fields for the room corresponding to the port they are
using.
If required, click on the check box for
3.
If you enabled In Room Port Mapping, you must assign a
will need these when you perform port mapping from the subscriber side of the Access
Gateway.
Go to
"In Room Port Mapping" on page 155
Access Gateway.
For security reasons, this feature should be disabled when in room port mapping
(from the subscriber side of the Access Gateway) is completed.
Select
4.
No Port Location Mapping
If you are using an access concentration device that cannot handle VLAN IDs, select one
5.
of the available Access Concentrator Query options:
The devices in the following list must be assigned an IP address on the same
subnet as the Access Gateway. You must remove "old" concentrator types before
entering new ones.
Tut Systems Expresso
Lucent DSL Terminator
Tut MDU Lite Systems
RFC1493 Compliant Systems
RiverDelta 1000B
Elastic Networks
System Administration
In Room Port Mapping
to map rooms from the subscriber side of the
if you are not using Port-based access.
to enable this feature.
Username
and
Password
. You
153
Advertisement
Table of Contents
