Table of Contents
Advertisement
If the Access Gateway receives its IP address from a
Configure PPPoE Client
Enter a valid IP address in the
7.
The IP addresses from subscribers that are on a subnet different from the Access Gateway
(for example, misconfigured) are translated by Nomadix' Dynamic Address Translation
(DAT) patented technology to the
The subscriber interface acts as a multifunctional "translator." For example, if a
subscriber's computer is setup statically for a network with a gateway address of
10.1.1.1, the Access Gateway emulates the gateway to accommodate this
subscriber while emulating other gateways to accommodate other subscribers.
Enter a Valid Subnet Mask in the
8.
The subnet mask defines the number of IP addresses that are available on the routed subnet
where the Access Gateway is located.
Enter a valid default gateway IP address in the
9.
136
link and enter the following parameters:
PPPoE Service Name -
allowed length is 31 characters.
PPP Keep Alive
•
Echo Request Interval in seconds -
echo requests from the NSE. The default value for this parameter is
30 seconds.
•
Maximum Missed Responses allowed -
echo-requests that can be allowed to go without a response before
the NSE determines that the PPP link is down. This parameter can
only set to whole number above 0.
PPP Authentication
•
Username -
required by your service provider.
•
Password -
required by your service provider. Max length for both username
and password is 128 characters.
IP Configuration Mode -
the NSE. Setting this to Dynamic will obtain a dynamic IP address from PPPoE
server similar to DHCP client. Setting this to static will require manually
configuring IP address in the text box.
Maximum TCP MSS -
maximum value suggested by the RFC
Network IP Address Field
This is the Service-Name TAG. The maximum
This is the username for PPP based authentication
This is the password for PPP based authentication
This defines the IP address configuration mode for
Please note that this is the MSS not MTU. The
is 1452.
Network IP Address.
.
Subnet Mask Field
Default Gateway
A
CCESS
, select the
PPPoE Server
Setting this to 0 will disable
This is the number of
.
field.
System Administration
G
ATEWAY
Advertisement
Table of Contents
