Table of Contents
Advertisement
Check Enable NAT Traversal to allow packets to traverse NAT/IPsec boundaries.
3.
Click
4.
Submit
To add or modify IPsec tunnel peers, see
add or modify IPsec security policies, see
page
127.
Managing IPSec Tunnel Peers
You can add a new IPSec tunnel peer or modify the settings of an existing IPSec tunnel peer
from the IPSec Tunnel Settings screen.
Adding a new IPSec tunnel peer
Click the
1.
Add
screen opens.
Enter the IP address of the peer in the
2.
3.
Enter a Dead Peer Detection interval (integer value in seconds).
4.
Select the Internet Key Exchange (IKE) Protocol Version.
In the
5.
Peer Authentication Method
methods:
126
to save the setting.
button in the
IPSec Tunnel Peers
"Managing IPSec Tunnel Peers" on page
"Managing IPSec Security Policies" on
table. The IPSec Tunnel Peer Settings
field.
Tunnel Peer
section, select one of the two peer authentication
A
G
CCESS
ATEWAY
126. To
System Administration
Advertisement
Table of Contents
