Processor Fan Assembly - HP ProLiant BL40p Maintenance And Service Manual

Removal and Replacement Procedures

Processor Fan Assembly

To remove the processor fan assembly:
1. Power down the server blade and remove it from the server blade enclosure. Refer to the
"Server Blad e Preparation" section in this chapter.
2. Remove the access panel. Refer to the " Access Panel" section in this chapter.
3. Remove the system board tray assembly. Refer to the "Re moving the System Board Tray
Assembly" section in this c hapter.
4. Disconnect the fan cable from the system board. Refer to Figure 4-3 to identify the fan
cable connector.
5. Press the release levers on the front of the fan assembly (1), and slide the tray to the open
position (2).
Figure 2-26: Disconnecting the processor fan assembly
2-26
HP ProLiant BL40p Server Blade Maintenance and Service Guide