Boot Console Handler (Bch) For The Hp Integrity Rx7640 And Hp 9000 Rp7440 Servers; Booting An Hp 9000 Sx2000 Server To Bch; Hp-Ux For The Hp Integrity Rx7640 And Hp 9000 Rp7440 Servers - HP rp7440 Service Manual

Table 7-2 Typical Server Configurations for the HP 9000 rp7440 Server (continued)
Cell Memory Per
Boards Cell Board
Qty GBytes
2 8
1 8
The air conditioning data is derived using the following equations.
• Watts x (0.860) = kcal/hour
• Watts x (3.414) = Btu/hour
• Btu/hour divided by 12,000 = tons of refrigeration required
NOTE:
When determining power requirements you must consider any peripheral equipment
that will be installed during initial installation or as a later update. Refer to the applicable
documentation for such devices to determine the power and air-conditioning that is required to
support these devices.
Boot Console Handler (BCH) for the HP Integrity rx7640 and HP 9000
rp7440 Servers

Booting an HP 9000 sx2000 Server to BCH

After you power on the server or use the management processor (MP) BO command to boot an
nPartition past boot-is-blocked (BIB), the nPartition console will show activity while the firmware
is initialized and will stop at the BCH Main Menu (the Main Menu: Enter command or
menu> prompt).
Use the BCH DI command to redisplay the current menu and its available commands.
Main Menu: Enter command or menu > di
---- Main Menu ---------------------------------------------------------------
Command
-------
BOot [PRI|HAA|ALT|<path>]
PAth [PRI|HAA|ALT] [<path>]
SEArch [ALL|<cell>|<path>]
ScRoll [ON|OFF]
COnfiguration menu
INformation menu
SERvice menu
DIsplay
HElp [<menu>|<command>]
REBOOT
RECONFIGRESET
----
Main Menu: Enter command or menu >
For information about any of the available BCH commands, use the HE command.

HP-UX for the HP Integrity rx7640 and HP 9000 rp7440 Servers

HP supports nPartitions on cell-based HP 9000 servers. The HP 9000 rp7440 Server runs HP-UX
11i Version 1 (B.11.11).
178 HP Integrity rp7440 Server
PCI Cards DVDs
(assumes 10
watts each)
Qty Qty
8 2
8 1
Hard Disk Core I/O Bulk Power
Drives Supplies
Qty Qty Qty
2 2 2
1 1 2
Description
-----------
Boot from specified path
Display or modify a path
Search for boot devices
Display or change scrolling capability
Displays or sets boot values
Displays hardware information
Displays service commands
Redisplay the current menu
Display help for menu or command
Restart Partition
Reset to allow Reconfig Complex Profile
Typical Typical
Power Cooling
Watts BTU/hr
1871 6389
1237 4224