Turning The Copier On And Off - Oce 9400-I User Manual

Turning the copier on and off

Switching on the copier involves:
turning on the scanner
turning on the printer (see page 20).
Once the system has been turned on, it is ready for operation. In this state, the
machine is in stand-by mode. There is no need to turn it off after each copy job.
You can leave the copier turned on for the rest of the day. The Océ 9400-II is
ready for operation at all times.
If the copier is idle for more than 1 minute, the operating panel automatically
returns to stand-by mode. The scanner's operating panel is activated in the
following situations:
you feed in an original
you press a button on the operating panel
Turning on the scanne
Set the on/off switch, located at the back of the scanner, to position '1' (see
1
figur e3). If the electrical supply is correctly connected, the green switch will
light up.
[3] Scanner on/off switch
The system is ready for use immediately. You can turn the scanner on and
Note:
off independent of the printer, and you do not need to follow any particular
order in doing so.
18 Océ 9400-II User Manual