Reduction/Enlargeme Nt62; Copying Using Synchro Or Standard Cut62 - Oce 9400-I User Manual

Attention:
may get a paper jam, or the print job may use the wrong sheet of paper.
Manual feed time-out (see 'Setting the time-out for manual feed' on
Note:
page 51).
Reduction/enlargement
With the Océ 9400-II you can reduce or enlarge a copy with the range of 25%
to 400%. By pressing the 'zoom' button you can toggle between the fixed step
zoom mode and the % zoom mode. There are 8 pre-set zoom settings available
in fixed-step mode. You can select the zoom factor by using the 'up' or 'down'
button while the indicator is flashing. See also 'Overview of standard zoom
formats' on page 137.
Making reduced/enlarged copies with pre-set zoom setting
Press the zoom' button to activate the fixed step zoom mode.
1
Press the up' or 'down' button to select the required reduction/enlargement
2
ratio.
The display shows the selected ratio. If you make adjustments using this
button, one of the indicators above the button will flash. If the adjustment
differs from the default setting, the indicator will remain on. Confirm the
setting by pressing the zoom, edge, cut, media or start buttons.
Making reduced/enlarged copies with 1% increments
Press the zoom' button to activate the % zoom mode.
1
Press the up' or 'down' button to select the required reduction/enlargement
2
ratio.
The display shows the selected ratio. If you make adjustments using this
button, one of the indicators above the button will flash. If the adjustment
differs from the default setting, the indicator will remain on. Confirm the
setting by pressing the zoom, edge, cut, media or start buttons.
Copying using synchro or standard cut
In synchro cut mode, the copy is cut to the length of the original, taking into
account the zoom factor and the leading/trailing edge setting. Synchro cut
mode is selected by default.
62 Océ 9400-II User Manual
If you do not wait until the'FEED SHEET' message appears, you