Oce 9400-I User Manual page 24

Press 'next/select' to enter the '
5
Select the '
6
Press 'next/select' to enter the '
7
Select the '
8
Press 'next/select' to enter the '
9
Select the required setting usi
10
Press 'next/select' to confirm the selected type.
11
Press 'Program' to exit the main menu.
12
Defining the end-of-plot time-ou
Normally, print files end with an instruction that tells the printer that the file is
finished.
However, some print data files do not have an end-of-print instruction. In this
case, the print will be considered 'finished' when the printer stops receiving
graphic commands over the Centronics interface.
The print time-out option sets the delay after which the print is considered
finished. You can choose between 15, 30, 180, or 500 seconds. The default is
180.
Press 'Program' to enter the main menu.
1
Select the '
2
Press 'next/select' to enter the '
3
Select the '
4
Press 'next/select' to enter the '
5
Select the '
6
Press 'next/select' to enter the '
7
Select the '
8
Press 'next/select' to enter the '
9
Select the required plot time-out usi
10
Press 'next/select' to confirm the selected plot time-out.
11
Press 'Program' to exit the main menu.
12
24 Océ 9400-II User Manual
' item using the
CENTRONICS
' mode using the or
ECP
' item using t
CONFIGURATION
' item using the
CONNECTION
' item using the
CENTRONICS
' item using t
PLOT TIME OUT
' menu.
CONNECTION
or button.
' menu.
CENTRONICS
button.
' menu.
ECP
ng the or button.
he or button.
' menu.
CONFIGURATION
or button.
' menu.
CONNECTION
or button.
' menu.
CENTRONICS
he or button.
' menu.
PLOT TIME OUT
ng the or button.