Activating/De-Activating The Rewind Fun Ction58 - Oce 9400-I User Manual

no leading /trailing edge
auto exposure on; exposure setting 0.
Default settings are used in the following situations:
after turning the machine on
after pressing stop/correct twice
after a time-out of 1 minute (beginning from the completion of the previous
copy job).
If the 'start' button is pressed and the printer is not busy, the original will be
scanned. Once the original has been scanned, it will be returned to the operator.
No changes can be made to the settings during the scanning process.
After the original has been returned to you, you can remove it, feed in a ne
original and program the settings.
If the printer is busy at the moment you press the 'start' button, the ' P LEASE
WAIT' indicator lights up. Printing will resume 1 minute after the copying
process has finished. The scan will start automatically when the printer is ready
again.
Activating/de-activating the rewind function
The default setting is configured by the Océ service technician.
Note:
If you have a valuable or delicate original, you may prefer not to have the
original returned to the operator. In this case, you can use the 'start' button to
activate an override of the default settings.
Three default settings are possible:
the original is rewound after scanning;
1
the original is rewound after scanning, unless you tell the scanner to leave the
2
original at the back of the scanner;
the original is not rewound unless you tell the scanner to feed the original back
3
to the front of the scanner.
If you feed an original and the rewind function is not active, you must press the
'start' button only for the first original. Subsequent originals will be fed
automatically (stream feed). Make sure you have chosen new settings before
feeding the original.
58 Océ 9400-II User Manual