Oce 9400-I User Manual page 46

While pressing the knob, slide the roll holder into the roll of print material (see
4
figur e11 on pa ge42).
Make sure that the knob is to the right, and that the paper appears as shown in
figure 11.
While pressing the knob, align the roll with the appropriate lines on the roll
5
holder
Place the roll holder with the material in the lower paper compartment (see
6
figur e16).
[16] Repositioning the roll
Feed the material between the input guide plates against the rollers. Turn the
7
rollers until the material is visible (see f igure17). You can also refer to the
sticker inside the drawer.
[17] Feeding the material
If you have inserted a roll with a different material or of a different width, you
8
must program the correct width and material type (see Programming media
settings' on page 4 9 ).
46 Océ 9400-II User Manual