Oce 9400-I User Manual page 141

Open a terminal session on your host (e.g. WINDOWS terminal) with the
4
following settings:
baud rate
data b
stop b
parity
flow control
Turn the printer on.
5
You will be prompted to press the CTRL-P key with the following message:
6
"Press CTRL-P to update the application / fls/EPC-M1........"
You have 5 seconds to press this key, otherwise the controller will not update
the firmware.
When CTRL-P is pressed, you are prompted to confirm your choice.
7
"You have pressed CTRL-P key"
"Do you confirm to update the file application /fls/EPC-M1?"
"Y confirm / N cancel"
If you press N, the controller will start with its current firmware version.
8
If you press Y, you are prompted to send the new firmware file through the
9
Centronics port:
"Transfer controller software through the Centronics port".
Send the new firmware file from your host, e.g. on a DOS session on a PC:
10
copy /b EPC-M1_1.0.ld lpt1
The following messages allow you to monitor the progress on the terminal
11
window:
"Loading file"
"Transfer progress xx%"
'Transfer successful, checksum 0x........"
"Writing to Flash"
"Erase Flash ...... done"
"Writing progress: xx%"
"Done"
"Operation Complete"
"Transfer successful"
"Turn machine OFF then ON to apply modifications"
Turn the printer off.
12
Controller firmware upgrade
9600
8
1
none
none
141