Oce 9400-I User Manual page 63

In standard cut mode, the copy is cut at a standard format (portrait). You select
the width of the standard format with the 'up' or 'down' button.
Example: selecting 36 inches means that you select a 36-inch width format
and a corresponding 48-inch length. The material is cut to a length of 48 inches
regardless of the roll width.
Depending on the ISO, ANSI or ARCH range specified, you get the paper
Note:
sizes displayed in the corresponding column (see 'Order of standard sizes for
using standard cut' on p a ge138).
If you make adjustments in standard mode using the cut button, the standard'
indicator above the button flashes. After confirming the standard selection, the
indicator remains on. Confirm the setting by pressing the zoom, edge, cut,
media or start buttons.
When standard cut is selected, the system always cuts at the selected length. It
does this even if the actual length of the original is shorter or longer than the
selected length (taking into account the zoom factor and the leading/trailing
edge setting).
Selecting synchro or standard cu
Press the 'cut' button to select the cut mode you want. The selected cut mode's
1
indicator will light up.
If you select standard cut:
Press the 'up' or 'down' button' to select the required cut length.
2
The required length is shown in the operating display. Confirm the setting by
pressing the zoom, edge, cut, media or start buttons.
For an overview of the possible standard lengths, see 'Order of standard sizes
for using standard cut' on pag e138.
Copy jobs 63