Bitmap Buffe R37 - Oce 9400-I User Manual

Bitmap buffer
This buffer defines a percentage of the total RAM memory that can be used as
the bitmap partition. This value will be set between two values, depending on
the RAM configuration.
The installed RAM can be divided into the following sections:
bitmap partition
processing area for files
The size of the bitmap partition determines the maximum length of the image
to be printed on a given paper roll (or manual sheet).
The size of the buffer setting must be adjusted according to the type of roll you
use and the print length of your file (or original).
There is no need to use a larger bitmap buffer than required. In fact, this may
result in a loss of space for the processing area.
The minimum percentage always represents an E+ size. If you never print or
copy files and/or originals that exceed the E+ length (48"), you must set the
minimum Bitmap buffer percentage.
If you print or copy files and/or originals that exceed this length, you must set
the correct Bitmap buffer size.
Use the following formula to determine the percentage setting: (Paper width *
print length * conversion factor) / controller memory configuration.
Conversion factor = 1.08 (width and length in inches)
Example: you print 70" on D+ paper and you have 64 MB of memory;
BM% = 24 * 70 * 1.08 / 64 = 29%.
Example: you print 6 meters on an A0 paper and you have 128 MB of memory
BM% = 841 * 6000 * 1.67E-3 / 128 = 66%.
Setting the bitmap buffer
Press 'Program' to enter the main menu.
1
Select the 'C
2
Press 'next/select' to enter the 'C
3
Select the '
4
Installing the printer
1.67 E-3 (width and length in mm).
' item using t
ONFIGURATION
' item using the
BUFFERS
he or button.
' menu.
ONFIGURATION
or button.
37