Oce 9400-I User Manual page 43

Place the roll holder with the material in the drawer (see figu re12).
6
[12] Repositioning the roll
Feed the material between the input guide plates against the rollers.
7
Turn the rollers until the material is visible (see f igure13). You can also refer
8
to the sticker inside the drawer.
[13] Feeding the material
If you have inserted a roll with a different material or of a different width, you
9
must program the correct width and material type (see 'Programming media
settings' on pag e49).
If you want to cut the paper to get a straight leading edge, see 'Cutting the
paper to get a straight leading edge' on page 4 4 .
Otherwise, continue with the next step.
Close the drawer.
10
Press the 'Cancel/Continue' button.
11
(Re)load media and toner 43