Configuring Preferred Tunnel Path - Cisco CRS Configuration Manual

Configuring Preferred Tunnel Path

Example:
RP/0/RP0/CPU0:router(config-if)# service-policy input servpol1
Attaches a QoS policy to an input or output interface to be used as the service policy for that interface.
Step 4 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Preferred Tunnel Path
This procedure describes how to configure a preferred tunnel path.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-class {name}
4. encapsulation mpls
5. preferred-path {interface} {tunnel-ip value | tunnel-te value | tunnel-tp value} [fallback disable]
6. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enters the configuration mode.
Step 2
l2vpn
Example:
RP/0/RP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3
pw-class {name}
Cisco IOS XR Virtual Private Network Configuration Guide for the Cisco CRS Router, Release 6.1.x
26
Implementing Point to Point Layer 2 services