Locking The Lens Motor; Resetting The Lens To Home Position; Selecting Screen Image Orientation - Christie Inspire Series User Manual

Locking the lens motor

Prevent all lens motors from moving. It disables the zoom, focus, and offset settings, locking out
any changes and overriding all other lens features. This feature prevents accidental lens position
changes in multiple projectors installations.
1. Select Menu > Configuration > Lens Settings > Lock all Lens Motors.
2. To enable locking of all lens motors, select Locked.
3. To unlock all lens motors, select Allow.
4. To confirm the selection, select ENTER.

Resetting the lens to home position

Set the lens offset back to the home position.
To make sure the lens shift is functioning properly, Christie recommends calibrating the lens every
time the lens are changed.
1. Select Menu > Configuration > Lens Settings > Lens Calibration.
You can also select LENS on keypad or LENS H/LENS V on remote control.
2. To start the lens calibration, select ENTER.
3. To start the lens calibration, select OK.

Selecting screen image orientation

Specify the orientation to use for the image. The projector supports front projection, rear
projection, front projection inverted, or rear projection inverted.
1. To invert the projection image, select Menu > Configuration > Ceiling Mount.
2. Select appropriate ceiling mount settings:
• Auto—Detect the orientation automatically.
• Off—Disable the ceiling mount setting.
• On—Enable the ceiling mount setting.
3. To confirm the image orientation, select ENTER.
4. To do a rear projection, select Menu > Configuration > Rear Projection.
5. To swap, select ENTER.
Inspire Series 4K User Manual
020-002098-01 Rev. 1 (09-2023)
Copyright © 2023 Christie Digital Systems USA Inc. All rights reserved.
If printed, please recycle this document after use.
Configuring system settings
52