Omron FQ2-S Series User Manual page 93

• Teaching
Set the measurement regions and measurement directions for both edge 0 and edge 1.
[Image] − [Image adjustment] − [2Edge position comp.] − [Modify] − [Basic]
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured,
and then press [OK].
This concludes setting the measurement region and
edge search direction for edge 0.
Next, go to step 4 to set the measurement region and
edge search direction for edge 1.
4 −
Press [ ] [Edge1 region] on the right of the dis-
play, move the rectangle to the location to be mea-
sured, and then press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
• Source Image
You can select the image to which to apply the results of position compensation processing.
Applying the Results of Position Compensation: p. 83
• Interpolation
You can select the precision of position compensation.
If you select [Bilinear], the precision of position compensation will increase.
[Image] − [Image adjustment] − [2Edge position comp.] − [Modify] − [Details] − [Interpolation]
The settings are the same as those for the Shape Search Position Compensation item.
Interpolation: p. 85
FQ2-S/CH User's Manual Adjusting the Images That Were Taken
91