Changing The Label Detection Conditions - Omron FQ2-S Series User Manual

• Sensors with Monochrome Cameras (or for a Color Gray Filter)
1
] − [Binary level] on the right of the display.
Press [
2
Specify the range of brightness to detect, and then
press [OK].
Specify the range of brightness to convert to a binary im-
age. Measurement is performed after the image taken by
the camera in 256-color grayscale is converted to a bina-
ry image. Then, white pixels are measured.
3
Press [OK].
4
Press [TEACH].
5
Press [Back] to end teaching.
Note
Making the Extraction Results Easier to Check
• You can invert the black/white extraction results.
− [Reverse] and select [Yes].
[ ]
Press
• You can select whether to display a binary image.
− [Binary image display] and select [OFF] or [ON].
[ ]
Press

Changing the Label Detection Conditions

You can fill in the labels detected through color extraction or binary conversion to perform a stable extraction of
the labels and their characteristics or to mark only labels inside the measurement region for inspection.
− [Inspection] −
[Inspect]
1
To enable filling up holes, press [Filling up holes]
and select [Yes].
2
To extract an image, press [Extract image] and select
[Yes].
208
Inspecting with the Labeling Inspection Item
− −
[Labeling] [Modify] [Details] Tab Page
−
[Meas. Parameter]
FQ2-S/CH User's Manual