Part Names And Functions - Omron FQ2-S Series User Manual

2-2 Part Names and Functions

FQ2-S1 FQ2-S2 FQ2-S3
FQ2-S@@@@@@-@@@ (Sensors with Built-in Lighting)
FQ2-CH1@@@@@-M (Sensors with Built-in Lighting)
(6)
(7)
No. Name
(1) Lighting
(2) Camera lens
(3) I/O Cable connector
(4) Ethernet cable connector
(5) Focus adjustment screw
(6) Operation OR
indicators
ETN
ERROR
BUSY
(7) Mounting Bracket
FQ2-S/CH User's Manual
FQ2-S4 FQ2-CH
(5)
(1)
(2)
(4)
(3)
Description
LEDs for illumination
This lens can be focused.
An FQ-WD or FQ-WU I/O Cable is used to connect the Sensor to the power
supply and external I/O.
An FQ-WN Ethernet Cable is used to connect the Sensor to external
devices such as PLCs, the Touch Finder, or computers.
Used to adjust the focus of the image.
Lights orange when the overall judgement output (OR) signal turns ON.
Lights orange during Ethernet communications.
Lights red when an error occurs.
8-1 Error Histories: p.298
Lights green when the Sensor is executing a process.
* You can change the BUSY indicator to a RUN indicator.
This indicator is set by default to a BUSY indicator, but if you change it to a
RUN indicator, it will light green during operation.
Changing the Sensor's BUSY Indicator: p.295
Used to mount the Sensor.
The Mounting Bracket can be attached to the front, left side, right side, or
back of the Sensor.

Part Names and Functions

35