Table of Contents
Advertisement
3
Press [OK] to enter the value.
Item
Judgement parameters
Note
• You can change the output form for each measurement value to one of the following settings.
− [Result type] on the right of the display.
[
]
Press
Absolute value (default): The measured edge width is output.
Relative value: The difference from the reference value is output.
Ratio: The percentage of the reference value is output.
Changing Edge Detection Conditions (Sensors with Monochrome Cameras Only)
You can change the measurement conditions for Sensors with Monochrome Cameras. Change the [Density
change] and [Measurement method] parameters.
p. 176
Reflect in Total Judgement
You can specify whether to reflect the judgement results of an inspection item in the overall judgement. (The
default is to reflect them.)
−
[Inspect]
[Inspection]
Unstable Edge Width Results (Sensors with Color Cameras)
If the measurement result is not stable, adjust the [Edge level], [Noise level], and [Set color.] parameters.
p. 176
Increasing Edge Width Processing Speed
Make the measurement region smaller to reduce the processing time.
Changing the measurement region: p. 155
184
Inspecting with the Edge Width Inspection Item
Parameter
Setting
Edge width (edge in
When the result type is set to abso-
width)
lute value
Range: 0.0000 to 99,999.999
Defaults: Upper limit: 99,999.999,
Lower limit: 0.0000
When the result type is set to relative
values:
Range: −99,999.9999 or
99,999.999
Defaults: Upper limit: 99,999.9999,
Lower limit: −99,999.9999
When the result type is set to ratios:
Range: 0.000 to 999.9999(%)
Defaults: Upper limit: 999.9999,
Lower limit: 0.000
−
−
[Add item.]
[Edge Width]
Description
Set the upper and lower limits of the
reference width for an OK judgement.
−
−
[Details] Tab Page
[Output parameter]
FQ2-S/CH User's Manual
Advertisement
Table of Contents
Troubleshooting
