Creating New Scenes
The default scene number is 0. To create another scene, use the following procedure to switch the scene and
then make the settings.
(Setup Mode) − [Select scene]
1
Press the number of the scene to change to and then
press [Select].
2
The scene will change. Make the settings for the
scene.
Changing Scene Names, Copying Scenes, and Deleting Scenes
(Setup Mode) − [Select scene]
1
Press the number of the scene and then press [Re-
name], [Copy], or [Clear].
2
To change the name, enter a new scene name in 15 al-
phanumeric characters or less.
To copy a scene, press the number of the scene to
copy.
Switching Scenes from an External Device
• Changing Scenes by Parallel Input Command
Vision Sensor FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
Section 2 Controlling Operation and Outputting Data with a Parallel Connection
• Changing Scenes by PLC Link Command
Vision Sensor FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
3-2 Controlling Operation and Outputting Data with PLC Link Communications
• Changing Scenes by EtherNet/IP Command
Vision Sensor FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
3-1 Controlling Operation and Outputting Data with EtherNet/IP Communications
• Changing Scenes by TCP No-protocol Command or a UDP No-protocol Command
Vision Sensor FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
3-4 Control and Output in No-protocol (TCP) / No-protocol (UDP)
• Changing Scenes by FINS/TCP No-protocol Command
Vision Sensor FQ2-S/CH Series User's Manual for Communications Settings (Cat. No. Z338)
3-5 Controlling Operation and Outputting Data with FINS/TCP No-protocol Commands
FQ2-S/CH User's Manual
Changing the Scene to Change the Line Process
251