Omron FQ2-S Series User Manual page 185

Step 2 Teaching
Teaching means to store the region and the edge width in the region as reference data for the measurement.
− [Inspection]
[Inspect]
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
Changing the measurement region: p. 155
The following data is stored as the measurement reference.
Item Parameter
Reference data Reference width
Step 3 Adjusting the Judgement Parameters
− [Inspection]
[Inspect]
1
Press [Judgement].
2
Set the D. Width range for an OK judgement.
Continuous measurements will be performed for the im-
ages that are displayed. The measured value is dis-
played beside the parameter name.
Note
You can change the parameters for judgement conditions on the
Display Settings Display. Press
of the display to switch to the Display Settings Display.
FQ2-S/CH User's Manual
− [Add item.] − [Edge Width] − [Settings] Tab Page
Description
The reference edge width is set automatically.
− [Add item.] − [Edge Width] − [Settings] Tab Page
− [Display setting] on the right
[ ]
The middle arrow is the
direction for detecting an edge.
Moves the starting point
of the measurement
region.
Drag to move
the region.
Lower limit
Blue for OK. Red for NG.
Inspecting with the Edge Width Inspection Item
Moves the end point
of the measurement
region.
Changes the width
of the measurement
region.
Upper limit
183